261.
According to Roofing Construction & Estimating, metal flashing for fireplaces and chimneys should extend out onto the shingles at least inches.
A
3
B
4
C
5
D
6
Loading practice questions
Browse topic-based Civil and Mechanical Engineering practice sets.
1131 practice sets · Page 14 of 57
According to Roofing Construction & Estimating, metal flashing for fireplaces and chimneys should extend out onto the shingles at least inches.
3
4
5
6
Who is responsible for fire equipment at the kettle?
Employer
Fire marshal
Kettle worker
Home owner
According to Roofing and Construction Estimating, when installing a woven valley, the contractor should
Extend the shingle 36 inches beyond the centerline
Extend the shingle 12 inches beyond the hip line
Use double underlayment 30 pound felt or higher
Extend the shingle 12 inches beyond the valley centerline
Which should not be soldered according to Roofing and Construction Estimating?
Aluminum
Copper
Lead
Nickel alloys
According to Roofing and Construction Estimating, when installing a woven valley, the contractor should
Use double underlayment
Use 50 pound or heavier roll roofing
Overlap the shingles at least 36 inches
Nail the shingles 12 inches on center
Which of the following may be used with EPDM systems?
Seam caulk
Coal tar
Asphalt
Oil-based roofing cement
According to Roofing and Construction Estimating, valley flashing metal shall
Extend beyond the ridge
Extend 12 inches beyond the ridge
Extend 18 inches beyond the ridge
Extend 24 inches beyond the ridge
Which of the following is not a single-ply roofing system?
CPE
PVC
CSPC
PIB
According to Roofing and Construction Estimating, the drip edge should be installed
Under the felt along the eaves and under the underlayment along the rakes
Over the felt along the eaves and under the underlayment along the rakes
Over the felt along the eaves and over the underlayment along the rakes
Under the felt along the eaves and over the underlayment along the rakes
Which of the following is especially vulnerable to leakage?
Chimneys
Eaves
Valleys
Counterflashing
According to Roofing and Construction Estimating, never install lightweight concrete decks on roofs with slopes greater than
1/8 in 12
1/4 in 12
1/2 in 12
1 in 12
Which of the following has the greatest coefficient, of thermal expansion?
Steel
Copper
Aluminum
Zinc
According to Roofing and Construction Estimating, it is a good practice when installing Stab shingles to use which material to flash valleys?
Modified bitumen
Mineral surfaced roll roofing
Double 30 pound felt
Metal flashing
Which is not a type of downspout?
Plain rectangular
Corrugated rectangular
Plain round
Ogee
According to Roofing and Construction Estimating, do not install pitch bitumen over roof slopes more than
1/8 in 12
14 in 12
1/2 in 12
1 in 12
Which is not a factor regarding end laps?
Local code requirements
Severity of the climate
Slope of the chimney cricket
The type of underlayment
A gutter is 3 inches by 4 inches. The total cross-sectional area is
14 inches
12 inches
7 inches
49 inches
Where a sloping roof meets a vertical wall, flashing must be at least how many inches high?
8
10
12
5
The roof should be loaded by stacking bundles of shingles
Along the edges
Anywhere on the roof
Along the ridge
Along any horizontal space
When using the mortar-set method on roof slopes of 5 in 12 each eave tile requires how many nails in addition to using mortar?
1
2
3
Nails are not required