Tools and Machines : Practice Questions and Answers

When applying a water-based stain, brush the end grain with.........to prevent it from absorbing too much stain.

When adjusting the sliding compound miter saw, loosen the locking handle or lever and tilt the.............to the desired angle.

Veneering techniques have been used for at least..............years.

Trim excess stock from a rabbet using a

To mix a white stain, combine..............with oil and turpentine.

To make a miter cut, adjust the miter gauge to the correct angle and proceed as for

To lay out a dado, superimpose the end of the second board across the...............of the first.

To cut a groove for a strip of inlay, use a.............bit.

To cut a bevel, adjust the track for

There are three basic steps to installing a drawer in a table:.............., making the drawer, and installing drawer guides.

The.................presses firmly on the top of the wood to prevent the grain from tearing out.

The width of the mortise should be the same as the..............of the tenon.

The width of the cut made for a rabbet joint is determined by the

The width of a tenon should be............inches or less.

The vertical part of a shoulder is cut with a

The two main types of butt joints include edge butt joints and

The two basic types of hardware are cabinet hardware and

The top grade of hardwood lumber is labeled

The three keys to good design include

The thickness of a tenon should be..............the thickness of the piece in which the mortise will be cut.