1.
Woods greatest commercial importance is in
A
making paperboard and cardboard.
B
furniture, cabinetmaking, and building construction.
C
engineered wood production.
D
production of synthetics and plastics.
Loading practice questions
141 practice sets · Page 1 of 8
Woods greatest commercial importance is in
making paperboard and cardboard.
furniture, cabinetmaking, and building construction.
engineered wood production.
production of synthetics and plastics.
Wooden parallel clamps from 6 to 20 inches long are called
pipe clamps.
C-clamps.
hand screws.
bar clamps.
While making a cut, the blade of the saw extends into a slot in the
kerf board.
fence.
angle indicator.
turntable.
Which type of gloves should be worn when working with sharp edges and rough materials?
lightweight cotton
leather or thick fabric
rubber
plastic
Which sander is most useful for getting into hard-to-reach places?
oscillating spindle sander
stationary disc sander
stationary belt sander
narrow belt sander-grinder
Which of the following would not be found on a bill of materials?
rough size of each wood part
fasteners
accessories
finished size of each wood part
Which of the following is usually not cut with a plunge router?
edge
mortise
rabbet
dado
Which of the following is used to cut irregular shapes?
compass saw
backsaw
dovetail saw
ripsaw
Which of the following is not used as a marking tool?
utility knife
scratch awl
triangle
lead pencil
Which of the following is not recommended for sanding?
Never use a coarser grit than necessary.
Always sand against the grain.
Take care to prevent round corners.
Sand end grain in only one direction.
Which of the following is not recommended for planing?
None of the above.
If you are right handed, grasp the knob in your left hand.
Lift the plane off the board on the return stroke.
Always plane with the grain.
Which of the following is not recommended for driving nails?
Do not put several nails along the same grain.
Grasp the hammer near the head.
Hold the nail close to the point.
Watch the hammer, not the nail.
Which of the following is not recommended for chiseling?
Never allow the edge to touch other tools.
Secure the workpiece with clamps.
Keep the chisel close to your body.
Always hit the tool squarely on top of the handle.
Which of the following is not involved in an electric shock that kills?
paralysis of the hand or other muscles.
a slowed heart rate.
ventricular fibrillation.
respiratory-center paralysis.
Which of the following is not an advantage of the sliding compound miter saw?
It can be taken to construction sites.
It can cut dadoes.
It is safer than a radial-arm saw.
It can cut angles easily.
Which of the following is not a step in problem solving?
Rank the solutions according to effectiveness.
State the problem clearly.
Select the best solution.
Collect information.
Which of the following is not a softwood?
cedar
pine
redwood
birch
Which of the following is not a helper used to feed stock into a tool?
straightedge
pushstick
featherboard
pushblock
Which of the following is not a hardwood?
cherry
fir
maple
walnut
Which of the following is a penetrating finish?
Danish oil
varnish
enamel
shellac