101.
Most fires can be extinguished by
A
increasing the level of oxygen.
B
all of the above.
C
increasing the heat so the fire burns more quickly.
D
removing the source of fuel.
Loading practice questions
141 practice sets · Page 6 of 8
Most fires can be extinguished by
increasing the level of oxygen.
all of the above.
increasing the heat so the fire burns more quickly.
removing the source of fuel.
Large machines with two belts arranged on three pulleys are capable of..............speed settings.
nine
twelve
three
six
In cutting curves
make relief cuts to within 1/4 inch of the layout line.
all of the above.
apply even, forward pressure.
guide the work with your right hand.
In a dado joint, a(n).................across one board receives the end of another board.
groove
lap
L-shaped cut
dado
If the pattern for your workpiece includes loose curves, choose a.............blade.
wide, thick
saber
thin, narrow
long
If a chemical splashes into someones eye, the person should rinse the eye with
mercurochrome.
cold tea.
alcohol.
a gentle stream of cool water.
Hand tools used to cut a tenon include a backsaw or
dovetail saw.
ripsaw.
fine crosscut saw.
table saw.
Hand tools used to cut a mortise include a drill and a
miter box.
all of the above.
chisel.
dado cutter.
Flat cutting produces a
patterned grain.
cathedral grain.
flat grain.
irregular grain.
Employers appreciate workers who
cooperate.
all of the above.
have a positive attitude.
can accept criticism.
During sanding, the movement of the abrasive against the wood generates
friction.
tension.
static electricity.
adhesion.
Dowel centers are
pieces of dowel rod used to strengthen joints.
none of the above.
small metal pins used for marking.
the wooden cores of dowel rods.
Do not allow your fingers to come closer than.,............inches to the blade on a table saw.
2
3
4
5
Cutting several pieces at one time is called..............sawing.
pad
duplicate
repeat
pattern
Create a wash coat of one part.............to seven parts alcohol.
linseed oil
varnish
lacquer
shellac
Butt joints can be strengthened using corner blocks, biscuits, dowels, or
straps.
metal fasteners.
joists.
tape.
Butt joints are made by joining together the edge, end, or face surface of one piece of wood to the.............of another.
edge
end
face surface
all of the above
Built-in..............allow you to lock a power miter saw into position at a variety of angles.
metal clips
angle irons
index plates
none of the above
Boyles law refers to the relationship between
adhesion and cohesion.
volume and pressure of gases.
heating and cooling.
veneers and laminates.
Box joint is another term for a.......joint.
surface-lap
cross-lap
finger-lap
full-lap