61.
The width of the mortise should be the same as the..............of the tenon.
A
radius
B
width
C
length
D
thickness
Loading practice questions
141 practice sets · Page 4 of 8
The width of the mortise should be the same as the..............of the tenon.
radius
width
length
thickness
The width of the cut made for a rabbet joint is determined by the
thickness of the stock.
size of the saw blade.
desired strength of the joint.
size of the project.
The width of a tenon should be............inches or less.
2
5
4
3
The vertical part of a shoulder is cut with a
hermaphrodite caliper.
gouge.
skew.
parting tool.
The two main types of butt joints include edge butt joints and
angled butt joints.
end butt joints.
face butt joints.
corner butt joints.
The two basic types of hardware are cabinet hardware and
metal guides.
surface hardware.
structural hardware.
metal fasteners.
The top grade of hardwood lumber is labeled
common yard lumber.
factory lumber.
yard lumber.
FAS.
The three keys to good design include
proportion, balance, symmetry.
appearance, sound construction, function.
function, harmony, emphasis.
sound construction, scale, evaluation.
The thickness of a tenon should be..............the thickness of the piece in which the mortise will be cut.
twice
between one-third and one-half
less than one-fourth
three-fourths
The size of a power drill is determined by the size of its
bit.
chuck.
torque.
collar.
The size of a drill press is expressed as twice the distance from the center of the............to the column.
table
bit
chuck
spindle
The scroll saw is also called a
compass saw.
jigsaw.
coping saw.
band saw.
The reciprocating saw is used primarily for
rough cutting.
curved cuts.
finish cutting.
all of the above.
The radial-arm saw is sometimes called a............saw.
cutoff
table
combination
back
The most common saw blades are.............blades.
ripsaw
crosscut
combination
all of the above
The most common lap joint is the.................joint.
surface-lap
end-to-end half-lap
cross-lap
half-lap
The jointer is used to.............boards.
straighten
smooth
square up
all of the above
The first step in lumber processing is called
selective cutting.
barking.
air drying.
kiln drying.
The first step in crosscutting operations is to put the............in place.
miter gauge
rip fence
sliding T-bevel
stop block
The ends of the socket piece in a dovetail joint are called
pins.
half-pins.
tails.
blind ends.