Carpentry in Tools and Machines : Practice MCQ Questions & Answers with Explanations

When making biscuit joints, the slots should be slightly longer than the biscuits to allow for

When making a paneled door, use..............joints to connect stiles and rails.

When making a miter cut, adjust the............to the angle desired.

When making a dowel joint in a frame, use a................to locate the dowels on the face surface.

When edge jointing, hold the work face of the stock flat against the..............throughout the operation.

When cutting rectangular openings,

When cutting compound curves, first

When cutting a rabbet by hand, make the shoulder cut with a

When changing the belt on the stationary belt sander, first

When applying a water-based stain, brush the end grain with.........to prevent it from absorbing too much stain.

When adjusting the sliding compound miter saw, loosen the locking handle or lever and tilt the.............to the desired angle.

Veneering techniques have been used for at least..............years.

Trim excess stock from a rabbet using a

To mix a white stain, combine..............with oil and turpentine.

To make a miter cut, adjust the miter gauge to the correct angle and proceed as for

To lay out a dado, superimpose the end of the second board across the...............of the first.

To cut a groove for a strip of inlay, use a.............bit.

To cut a bevel, adjust the track for

There are three basic steps to installing a drawer in a table:.............., making the drawer, and installing drawer guides.

The.................presses firmly on the top of the wood to prevent the grain from tearing out.