221.
Special wood screws with widely spaced threads are available for use with
A
composition panels.
B
pocket holes.
C
sheet metal.
D
tabletops.
Loading practice questions
Browse topic-based Tools and Machines practice sets.
272 practice sets · Page 12 of 14
Special wood screws with widely spaced threads are available for use with
composition panels.
pocket holes.
sheet metal.
tabletops.
Short pieces of wood can be made into a longer, more usable piece by joining them with..........joints.
surface-lap
end-to-end half-lap
cross-lap
half-lap
Sanding discs are installed using
two wrenches of different sizes.
a tension knod.
pressure-sensitive adhesive.
a chuck key.
Rough turning is begun using a
gouge.
roundnose.
spindle.
none of the above.
Repair plates include mending plates and
flat corner irons.
bent corner irons.
T-plates.
all of the above.
Rabbet joints are commonly used in the construction of cases, cabinet frames, and
tabletops.
drawers.
roofing members.
picture frames.
Pumice is used to
remove old paint.
remove excess glue.
clean brushes.
rub down a finish.
Position the fence on a table saw so the distance from the outside of the blade to the fence is the same as the..............of the rabbet.
depth
length
width
none of the above
One way to support shelves in a bookcase is to drill holes in the sides and insert
shelf pins or dowels.
screws.
brackets.
cleats.
On some power drills, a chuck key is used to
loosen screws that are too tight.
none of the above.
tighten the jaws around the bit.
lock the drill for safety reasons.
Multispur bits are used
to cut dowels.
to cut rough holes.
to cut perfectly round, flat-bottomed holes.
to create countersinks.
Most fires can be extinguished by
increasing the level of oxygen.
all of the above.
increasing the heat so the fire burns more quickly.
removing the source of fuel.
Large machines with two belts arranged on three pulleys are capable of..............speed settings.
nine
twelve
three
six
In cutting curves
make relief cuts to within 1/4 inch of the layout line.
all of the above.
apply even, forward pressure.
guide the work with your right hand.
In a dado joint, a(n).................across one board receives the end of another board.
groove
lap
L-shaped cut
dado
If the pattern for your workpiece includes loose curves, choose a.............blade.
wide, thick
saber
thin, narrow
long
If a chemical splashes into someones eye, the person should rinse the eye with
mercurochrome.
cold tea.
alcohol.
a gentle stream of cool water.
Hand tools used to cut a tenon include a backsaw or
dovetail saw.
ripsaw.
fine crosscut saw.
table saw.
Hand tools used to cut a mortise include a drill and a
miter box.
all of the above.
chisel.
dado cutter.
Flat cutting produces a
patterned grain.
cathedral grain.
flat grain.
irregular grain.