21.
Which of the following cuts can be made with router bits?
A
all of the above
B
dovetail
C
V-grooving
D
cove
Loading practice questions
141 practice sets · Page 2 of 8
Which of the following cuts can be made with router bits?
all of the above
dovetail
V-grooving
cove
Which of the following cannot be sanded with a power sander?
none of the above
end grain
curves
irregular shapes
Which of the following can be used to cut veneer?
craft knife
utility knife
paper cutter
all of the above
Which is not true for finish turning?
The tool used is a skew.
Either cutting or scraping methods may be used.
Work is begun at the center of the workpiece.
None of the above.
Which is not done when applying an oil-based stain?
Wear rubber or vinyl gloves.
Sponge the wood surface with water.
Apply a thin coat of linseed oil to the wood.
Wipe all surfaces with a tack rag.
When wood pieces are simply lapped without additional processing, the joint is called a(n)
butt joint
surface lap joint
end-to-end half-lap joint
top-lap joint
When white or yellow glue is used to apply veneer, the veneer is pressed with a
household iron.
cast-iron weight.
rubber roller.
none of the above.
When using dowels to strengthen joints, their diameter should never be more than.............the thickness of the wood.
half
one-quarter
twice
three-fourths
When using a router with a jig and dovetail bit,
begin cutting from left to right.
certain joints must be cut on certain sides of the jig.
label the jig as well as the workpieces so that all parts match properly.
all of the above.
When using a crosscut saw, which of the following is not recommended?
Hold the saw at a 45-degree angle.
Apply light pressure on the push cuts.
Cut with the grain.
Cut on the waste side of the cutting line.
When storing a brush for a period of time, which of the following should not be done?
Wrap the brush in waxed paper.
Soak up the wetness with newspaper.
Wash it in detergent mixed with water.
Comb the bristles with a metal comb.
When spraying finishes, wear
rubber gloves.
an apron.
a mask or respirator.
all of the above.
When ripping with the table saw, use the..............to keep the saw kerf from closing.
antikickback pawls
arbor
splitter
try square
When pre-drilling wood for screws, drill the...............in the first piece of stock, then hold this piece over the second piece to mark the location for the pilot hole.
plug hole
shank clearance hole
countersink
counterbore
When planing a board, first
adjust the machine for the correct thickness.
start the stock into the planer.
measure the thickness of the board at the thickest point.
turn on the power.
When pieces of different thicknesses are joined, a.............joint is used.
surface-lap
cross-lap
finger-lap
full-lap
When operating a portable power sander
make sure the abrasive belt is in good condition.
wear goggles or a face shield.
start the tool above the work surface.
all of the above.
When making straight cuts,
use a special V fixture.
all of the above.
choose the widest blade possible.
make a sandwich of the material.
When making intricate internal cuts
adjust the guide to the correct height.
all of the above.
drill a relief hole in the center of the waste stock.
run the blade through a relief hole.
When making edge joints, pieces of stock wider than..............inches should be ripped into narrower strips and the strips glued together.
6 to 8
8 to 10
2 to 4
4 to 6