39 practice sets · Page 1 of 2
Which statements is true about the precedence of lines?
a hidden line has precedence over a center line
a center line has precedence over a visible line
a visible line has precedence over a miter line
all of the above
Which of the following projection methods does not use projectors perpendicular to the projection plane?
isometric
orthographic
oblique
axonometric
Which of the following is typically represented in a drawing but does not have a true physical counterpart on the object?
edge of planar surface
edge of a circular face
corner of a rectangle
limiting element of a curved surface
Which of the following is not a pictorial drawing?
isometric
multiview
perspective
axonometric
Where do the projection lines converge in a perspective sketch?
the vanishing point
the ground line
the horizon line
the eye point
When you want to make sure that all of the text stays to the right of a given point on the drawing, you wound set its
aspect
scale
alignment
font
When filling an area with a hatch pattern in AutoCAD the drafter needs to be able to
see the entire bounding area to hatch
set Ortho on
turn ISO grid off
set the layer to Defpoints
What type of sketches are typically used in the refinement stage of the design process?
isometric
document
oblique
ideation
What type of sketch uses a miter line?
a two-view multiview
an isometric pictorial
a three-point perspective pictorial
a three-view multiview
What type of sketch shows the front in true shape?.
isometric
perspective
oblique
axonometriC
What type of sketch incorporates convergence?
multiview
isometric
perspective
oblique
To avoid having to dimension to a hidden feature the drafter can utilize a ________ section
all of the above
Whole
Half
broken out
This type of section is not in direct projection from the view containing the cutting plane
Full section
Revolved section
Removed section
Broken-out section
The section view drawing in which one fourth of an object has been marked for removal is known as a ________ section
none of the above
Full
Half
Quarter
The internal angle of regular pentagon is ___ degree
150
72
108
120
The internal angle of regular hexagon is ___ degree
150
72
108
120
The following line is used for visible outlines
Short zigzag thin
Continuous thick
Continuous thin
Chain thin line
The following line is used for dimension line
Short zigzag thin
Continuous thick
Continuous thin
Chain thin line
The following is not included in title block of drawing sheet
Size of sheet
Sheet No
Scale
Method of Projection
The dotted lines represents
Hatching line
Hidden edges
Projection line
Centre line
