201.
The size of a power drill is determined by the size of its
A
bit.
B
chuck.
C
torque.
D
collar.
Loading practice questions
Browse topic-based Tools and Machines practice sets.
272 practice sets · Page 11 of 14
The size of a power drill is determined by the size of its
bit.
chuck.
torque.
collar.
The size of a drill press is expressed as twice the distance from the center of the............to the column.
table
bit
chuck
spindle
The scroll saw is also called a
compass saw.
jigsaw.
coping saw.
band saw.
The reciprocating saw is used primarily for
rough cutting.
curved cuts.
finish cutting.
all of the above.
The radial-arm saw is sometimes called a............saw.
cutoff
table
combination
back
The most common saw blades are.............blades.
ripsaw
crosscut
combination
all of the above
The most common lap joint is the.................joint.
surface-lap
end-to-end half-lap
cross-lap
half-lap
The jointer is used to.............boards.
straighten
smooth
square up
all of the above
The first step in lumber processing is called
selective cutting.
barking.
air drying.
kiln drying.
The first step in crosscutting operations is to put the............in place.
miter gauge
rip fence
sliding T-bevel
stop block
The ends of the socket piece in a dovetail joint are called
pins.
half-pins.
tails.
blind ends.
The end of each piece in a miter joint is commonly cut at an angle of...................degrees.
90
30 or 60
45
none of the above
The elevating crank is used to adjust
cutting width.
angle of cut.
depth of cut.
none of the above.
The drill press can be used for
drilling holes of various sizes and depths at various angles.
mortising.
sanding.
all of the above.
The depth of a rabbet is usually...............the thickness of the stock.
one-half to two-thirds
one-fourth to one-half
equal to
twice
The cutterhead on a jointer holds..............knives.
two
three
four
five
The correct depth for a dado is usually..................the thickness of the stock.
one-fourth
one-half
three-fourths
twice
The compound miter saw is referred to as compound because
it can do both crosscutting and ripping.
there is more than one miter gauge installed on the saw table.
it can cut two angled surfaces at the same time.
it can cut from above or below the workpiece.
Standard finishes are made with.................that emit(s) pollutants into the air.
water-based ingredients
solvents
fillers
rottenstone
Spindle turning involves turning stock held between the live center and the
spur.
headstock.
tool rest.
dead center.