81.
The end of each piece in a miter joint is commonly cut at an angle of...................degrees.
A
90
B
30 or 60
C
45
D
none of the above
Loading practice questions
141 practice sets · Page 5 of 8
The end of each piece in a miter joint is commonly cut at an angle of...................degrees.
90
30 or 60
45
none of the above
The elevating crank is used to adjust
cutting width.
angle of cut.
depth of cut.
none of the above.
The drill press can be used for
drilling holes of various sizes and depths at various angles.
mortising.
sanding.
all of the above.
The depth of a rabbet is usually...............the thickness of the stock.
one-half to two-thirds
one-fourth to one-half
equal to
twice
The cutterhead on a jointer holds..............knives.
two
three
four
five
The correct depth for a dado is usually..................the thickness of the stock.
one-fourth
one-half
three-fourths
twice
The compound miter saw is referred to as compound because
it can do both crosscutting and ripping.
there is more than one miter gauge installed on the saw table.
it can cut two angled surfaces at the same time.
it can cut from above or below the workpiece.
Standard finishes are made with.................that emit(s) pollutants into the air.
water-based ingredients
solvents
fillers
rottenstone
Spindle turning involves turning stock held between the live center and the
spur.
headstock.
tool rest.
dead center.
Special wood screws with widely spaced threads are available for use with
composition panels.
pocket holes.
sheet metal.
tabletops.
Short pieces of wood can be made into a longer, more usable piece by joining them with..........joints.
surface-lap
end-to-end half-lap
cross-lap
half-lap
Sanding discs are installed using
two wrenches of different sizes.
a tension knod.
pressure-sensitive adhesive.
a chuck key.
Rough turning is begun using a
gouge.
roundnose.
spindle.
none of the above.
Repair plates include mending plates and
flat corner irons.
bent corner irons.
T-plates.
all of the above.
Rabbet joints are commonly used in the construction of cases, cabinet frames, and
tabletops.
drawers.
roofing members.
picture frames.
Pumice is used to
remove old paint.
remove excess glue.
clean brushes.
rub down a finish.
Position the fence on a table saw so the distance from the outside of the blade to the fence is the same as the..............of the rabbet.
depth
length
width
none of the above
One way to support shelves in a bookcase is to drill holes in the sides and insert
shelf pins or dowels.
screws.
brackets.
cleats.
On some power drills, a chuck key is used to
loosen screws that are too tight.
none of the above.
tighten the jaws around the bit.
lock the drill for safety reasons.
Multispur bits are used
to cut dowels.
to cut rough holes.
to cut perfectly round, flat-bottomed holes.
to create countersinks.