Engineering Graphics : Practice Questions and Answers

When the drawing are drawn smaller than the actual size of object then scale is known as

When measurements are required in three consecutive units, the appropriated scale is

The unit of R.F. is

The R.F. of scale is always

The full form of R.F. is

In the diagonal scale, the word diagonal is used because it is most suitable for the measurement of

If the 10m length is represented as 1 mm on the map then representative fraction is

For scale, which one is not correct

For drawing of small instruments, watches etc. the scale used is

An area of 36 square kilometer is represented by 144 square centimeter on a map. What is the R.F. ?

A map of 10 cm X 8 cm represents an area of 50000sq. meter of a field. The R.F. of the scale is

Which of the following is not present in a circle?

Which of the following has an eccentricity less than one?

Which of the following conics has an eccentricity of unity?

For eccentricity in ellipse "e" which relation is correct?

The locus of a point moving in a plane such that the distance between a fixed point and a fixed straight line is constant is called

Which of the following is not a conic section?

The sections cut by a plane on a right circular cone are called as

When the plane cuts the cone at an angle parallel to the axis of the cone, then............is formed.

If the plane cuts at an angle to the axis but does not cut all the generators then what is the name of the conics formed?