Mercury does not wet glass. This is due to property of liquid known as
adhesion
cohesion
surface tension
viscosity
Browse topic-based Civil and Mechanical Engineering practice sets.
1131 practice sets · Page 45 of 57
Mercury does not wet glass. This is due to property of liquid known as
adhesion
cohesion
surface tension
viscosity
Property of a fluid by which its own molecules are attracted is called
adhesion
cohesion
viscosity
compressibility
To prevent the occurrence of dry rot below hollow timber ground floors, it is necessary to
ensure all d.p.c.s are correctly placed
use only well-seasoned timber
put a damp-proof membrane below the oversite concrete
ensure a through draught of fresh air
To keep the bed joints to the required thickness, it is advisable to
level the work frequently
lay the bricks frog-uppermost
use the gauge staff regularly
take great care with bed joints
The usual test for the workability of concrete is the
compression test
sieve test
silt test
slump test
The use of wall plates on the top of sleeper walls is to
provide equal distribution of load
increase the floor strength
reduce. the number of floor joists
form a level bedding surface
The type of material suitable for a flexible d.p.c. is
blue slate
bituminous felt
engineering bricks
mastic asphalt
The type of aggregate used for the manufacture of lightweight concrete blocks is
crushed sandstone
pulverised fuel ash
granite chippings
broken old bricks
The number of layers in which the slump cone is filled and the number of times each layer is rodded is
2; 25
3; 25
3; 35
4; 35
The minimum lap for a flexible d.p.c. is
50 mm
75 mm
100 mm
150 mm
The maximum thickness for hardcore when used below oversite concrete is normally
300 mm
500 mm
400 mm
600 mm
The horizontal d.p.c. is placed not less than150 mm above the
finished floor level
foundations
external ground level
oversite concrete
The first reading taken from an instrument position is termed the
foresight
datum sight
intermediate sight
backsight
The area of a brick which surrounds the frog is termed the
margin
stretcher face
arris
header face
The application of asphalt to basements in order to prevent penetration of water is described as
flaunching
tanking
benching
haunching
Stabilising a bricklayers line in windy conditions is carried out by using
line pins
corner blocks
heavy lines
tingle plates
Setting-out lines for walls which divide semidetached houses are derived from
return profiles
gauge staffs
single profiles
building squares
Sand-lime bricks are hardened by
steaming in an autoclave
firing in a continuous kiln
the addition of Portland cement
continuous spraying with water
Plasticisers used in mortars increase
strength
density
adhesion
workability
Intermediate level points between two previously established levels can be determied by using
boning rods
builders squares
trammel rods
gauge staffs