A focused practice platform for competitive-exam MCQs, subject wise, topic wise practice, and current affairs revision.

Practice library for exams, subjects, and daily revision. For learning purposes only.

ObjectiveMcq

Print Protected

Printing this content is disabled

This page is protected for print. Use the website to view the content.

During groove cutting in a lathe, by using a parting tool, w - Practice - ObjectiveMcq

During groove cutting in a lathe, by using a parting tool, which of the following forces are encountered?

Correct Answer: B — Tangential, Radial and Axial

Radial, axial and tangential forces are encountered during groove cutting on a lathe machine.

Effective teamwork and high productivity are good indications of positive
A profit maximizing firm will
Allowance of hole and shaft assembly is equal to
Minimum material limit of hole is
Minimum material limit of shaft is
Maximum material limit of hole is
Maximum material limit of shaft is
In an assembly of hole and shaft, smallest shaft was having diameter of 50.2 mm and largest hole was having diameter of 50.0 mm. Minimum interference in mm will be