A focused practice platform for competitive-exam MCQs, subject wise, topic wise practice, and current affairs revision.

Exams

SSC CGL
UPSC CSE
IBPS PO
RRB NTPC
CDS

Subjects

Mathematics
Physics
General Knowledge
English
Reasoning

Resources

Current Affairs
Search MCQs
Practice Sets

Company

About Us
Contact
Privacy Policy
Terms of Use
Disclaimer
Copyright

Practice library for exams, subjects, and daily revision. For learning purposes only.

© 2026 ObjectiveMcq.ComAll rights reserved

ObjectiveMcq

Print Protected

Printing this content is disabled

This page is protected for print. Use the website to view the content.

To reduce the total cutting time, the standard shaper is des - Practice - ObjectiveMcq

HomePracticeMachine Tools MatchingCutting ParametersTo reduce the total cutting time, t...

Cutting Parameters Machine Tools MatchingHard

To reduce the total cutting time, the standard shaper is designed to complete forward stroke______

Correct Answer: A — slowly

It is the desired property for standard shaper because only in forward stroke the useful work is done. So it should be slower than return stroke.

Related Practice

If t=0.b=s=v=1 and m=Find the value of l. l=length of the cutting stroke in mm, b=width of the work in mm, s=feed in mm, v=cutting speed in mm/minute, m=the ratio between return time to cutting time and t=machining time in minute.
If l=t=s=v=3 and m=Find the value of b. l=length of the cutting stroke in mm, b=width of the work in mm, s=feed in mm, v=cutting speed in mm/minute, m=the ratio between return time to cutting time and t=machining time in minute.
If n=2 (rpm of bull wheel), l=3 mm (length of cutting stroke) and m=5 (ratio of return time to cutting time), find the value of cutting speed in mm/minute.
If l=b=s=m=2 and t=Find the value of v. l=length of the cutting stroke in mm, b=width of the work in mm, s=feed in mm, v=cutting speed in mm/minute, m=the ratio between return time to cutting time and t=machining time in minute.
If l=b=s=v=3 and m=Find the value of t. l=length of the cutting stroke in mm, b=width of the work in mm, s=feed in mm, v=cutting speed in mm/minute, m=the ratio between return time to cutting time and t=machining time in minute.
If l=b=s=v=2 and t=2, find the value of m. (l=length of cutting stroke mm, b=width of work mm, s=feed mm, v=cutting speed mm/minute, m=ratio of return to cutting time, t=machining time minutes)
If l=b=s=v=2 and t=Find the value of m. l=length of the cutting stroke in mm, b=width of the work in mm, s=feed in mm, v=cutting speed in mm/minute, m=the ratio between return time to cutting time and t=machining time in minute.
If n=4 (rpm of bull wheel), cs=3 mm/minute (cutting speed) and m=5 (ratio of return time to cutting time), find the value of length of cutting stroke (l) in mm.